To verify that WireGuard is working, use our Connection check to check your IP.
DisconnectĪs before, you may replace "se3" with the currently used region. Note: Make sure that the configuration file name is no more than 15 characters long (not including ".conf"). You may replace "se3" with any of the other regions found on our server page. You will otherwise likely run into connectivity issues. If you're running WireGuard on multiple devices, generate a separate key pair for each device. Run our configuration scriptĬurl -LO & chmod +x. Sudo apt-get update & sudo apt-get install curl jq openresolv wireguardįor non-Debian based distributions, follow WireGuard's official installation instructions. The Mullvad VPN app for Linux uses the WireGuard protocol by default, so all you need to do is connect. We also have an easier setup guide which makes use of our browser-based config generator.
This advanced terminal-only guide will teach you how to use the WireGuard® protocol to connect to Mullvad using Linux.
0 kommentar(er)
